Fix-It Felix, Jr.
Finally got around to troubleshooting the timing circuit, and it looks like it’s up and running successfully now. Hooray! Turned out there were two problems: in the schematic, I had accidentally swapped a connection of the grayscale clock and the serial clock; and I had left the latch pin disconnected somehow. I’ll need to go double-check the other board now to make sure these same errors didn’t occur there, but even if they did, I can fix it with extra wires if needed. Regardless, it’s heartening to finally have this part of the project back under control.
Next steps could involve any of: Trying to connect this to the board itself, working on the control software, or wiring up the secondary boards. No idea which I want to tackle first.
Sorry, the comment form is closed at this time.
-
Archives
- November 2012 (2)
- October 2012 (1)
- September 2012 (4)
- July 2012 (2)
- June 2012 (7)
- May 2012 (6)
- April 2012 (5)
-
Categories
-
RSS
Entries RSS
Comments RSS